Cherchenie Vinogradov Reshebnik - Rabochaia Tetrad

To complete the task for a "long piece" in the , you must use break lines to shorten the visual representation while writing the actual total length on the dimension line. Ensure you include the necessary diameter symbols and any required cross-sectional views to fully define the part's geometry.

Leave a small gap in the middle of the part’s length and draw the break lines. This indicates that the middle section is omitted. 3. Add Dimensions cherchenie vinogradov reshebnik rabochaia tetrad

In the context of the (Technical Drawing) workbook by Vinogradov , the task involving a "long piece" (often referred to as a "длинная деталь" or "вал" in Russian) typically focuses on the convention of breaks (разрывы). This technique is used to represent long, uniform objects on a smaller sheet of paper without sacrificing detail at the ends. 1. Identify the Drawing Convention To complete the task for a "long piece"

For a long part with a constant cross-section (like a shaft or pipe), you should not draw the entire length to scale. Instead, use (линии разрыва). These are typically thin, wavy lines or "Z" shaped zigzag lines drawn by hand or with a ruler, depending on the specific standard (GOST) requirement in your workbook. 2. Prepare the Views This indicates that the middle section is omitted