If you get sound but no picture after flashing, your backlight inverter might be the issue, not the software.
Confirm your panel is set to the correct voltage (5V or 12V) via the jumper on the board.
💡 Always back up your current SPI Flash data using a programmer (like the RT809F or CH341A) before writing new firmware.
If you tell me the your TV is showing, I can help you: Identify if it's a software or hardware failure Find the service menu code for this board Select the correct LVDS cable for your Samsung panel
Place the file in the root directory (not inside a folder). Install: Turn off the TV power. Insert the USB drive. Turn on the power. The indicator light will flash rapidly during the update. Do not power off until the flashing stops. ⚠️ Critical Compatibility Check
Ensure the cable matches the Samsung bit-rate (usually 8-bit, single channel).
If your TV is stuck on the logo or won't turn on, follow these steps using a USB drive: Format a USB drive to FAT32 . Extract: Unzip the .rar file to get the .bin firmware file.
Before flashing, verify the following to avoid "bricking" your board:
Newsletter
